A warm, even floor without the upheaval you dread: our heating specialists plan the work room by room, test it before it is covered, and repair faults at source. Request your underfloor heating quote through the form.
Your underfloor heating job starts with a look at the floor: what is under it, how high it can rise and where the manifold can sit. From there we lift or prepare one room at a time, lay and pressure test the pipe or mat, finish the floor and commission the controls. That is how underfloor heating installation and repair in London runs with us.
The Quick Answer
- How wet and electric systems suit different London floors
- The stages the work runs in, one room at a time
- Which faults are fixed at the manifold, not under the floor
- How thermostats and zones keep each room at its own temperature
- Which homes and commercial floors we cover across Greater London
Dependable Heating is a heating and plumbing business covering London, with the same service available for boiler servicing in London and the plumbing around your floor.
Tell Dependable Heating about your floor in London through the form and get a quick, clear quote.
Underfloor Heating Installation and System Design
Most London houses we are asked to fit with underfloor heating already have a floor: floorboards on joists in a Victorian terrace, or a screed over concrete in a post-war flat. That decides the design before anything else does. A joisted floor takes pipe in routed aluminium spreader plates. A solid floor takes either pipe clipped to insulation board under a new screed or a thin electric mat under the tile.
The system is planned room by room: where the manifold sits, how the loops run, where the furniture will stand. Pipework in older terraces and mansion blocks is often retained and awkward to reach, so we look at the route before we promise a layout.
Good design is mostly good measuring.
Request a quote through the form for underfloor heating installation or repair in London from Dependable Heating, and tell us whether your floor is joisted or solid.
Wet and Electric Underfloor Heating Systems
A wet system is warm water in plastic pipe, fed from a manifold with a pump and mixing valve, and it suits whole floors and new screeds. An electric system is a heating mat or loose wire under the finished floor, and it suits a single bathroom or a kitchen where there is no room to build the floor up. Both spread heat evenly across the floor rather than in hot patches near a radiator.
The choice follows the floor height you can spare, the boiler you already have and how much of the house you want warmed. A wet system needs a heat source that runs at a low flow temperature. An electric mat does not touch your boiler at all.
Whether you need underfloor heating installation and repair in London or drain unblocking in London, we cover the whole area. Wet systems and drains often meet in the same ground floor works, so it helps to have one firm who can speak to both.
From London to City of Westminster, the same service is there when you need underfloor heating in City of Westminster fitted or repaired.
Two systems, one aim: an even warm floor.
Request a quote through the form for underfloor heating installation or repair in London from Dependable Heating, and tell us whether your floor is joisted or solid.
Installation, Repair and Maintenance Process for London Homes
Dust sheets and floor protection go down first, because the mess you fear is mostly a matter of preparation. The job then runs in stages, and you can usually keep using the rest of the house while one room is worked on.
- You describe the rooms and floors through the Quick Quote form and get a clear price back.
- We survey the floor, the manifold position and the heat source.
- The floor is lifted or prepared in one room at a time.
- Pipe or mat is laid, then pressure tested before anything covers it.
- The screed or floor finish goes down, then the controls are fitted and the system is commissioned.
Noise comes mainly from cutting boards and routing joists, and it is confined to the room being worked on. Screed needs time to cure before the final floor goes on, so that room waits while the others stay in use.
If you are searching for a plumber in London who can also handle the pipework around the floor, we cover that too, so one firm sees the job through. The pressure test is the step we never skip.
Underfloor Heating Repairs and Fault Finding for London Homes
A cold patch, a loop that stays cold, a pump that hums, a mat that no longer warms: each points somewhere different. Fault finding starts at the accessible parts, the manifold, the actuators, the pump and the thermostat, because most faults sit there and not under the floor.
That matters for the worry everybody has, that a fault means pulling up the floor. Often it does not. Balancing the loops, bleeding air and replacing a failed actuator all happen at the manifold. Where a fault is in the floor itself, we test to narrow down where it is before anyone lifts a board or a tile, so the opening is small.
We look first, then we tell you.
Controls, Thermostats and Heating Zones
Underfloor heating runs on low, steady heat, so the controls matter more than they do with radiators. A room thermostat with a floor sensor stops a stone or tile floor overshooting. Zoning lets a bathroom run on its own timing while the living room follows another.
On a wet system, the manifold carries a flow meter and actuator for each loop. Balancing those loops is what stops one room running warm and the next staying cold. We set it up so you can read it without a manual.
Simple controls get used. Complicated ones get ignored.
Commercial and Domestic Underfloor Heating
A flat conversion, a ground floor extension and a small office floor all want the same thing: even heat without radiators taking up wall space. The principles are the same in each, though larger floors need more loops and more careful balancing. We cover Greater London and the towns around it, including Westminster, Islington, Croydon, Harrow, Sutton and Wimbledon, for homes and landlords.
Tell us about the floor through the Quick Quote form and we will come back with a clear price.
Request a quote through the form for underfloor heating installation or repair in London from Dependable Heating, and tell us whether your floor is joisted or solid.
If this guide has told you what the problem is, the underfloor heating installation and repair page linked above explains how the visit runs and how it is priced, and the form below gets it booked.
Quick Quote Online








